![]() The entire solid tire shall be securely attached to the channel base and shall be without flat spots or bumpy rubber.Ģ7453. The required thickness of rubber shall extend evenly around the entire periphery of the tire. The rubber of a solid tire shall be measured between the surface of the roadway and the nearest metal part of the base flange to which the tire is attached at the point where the concentrated weight of the vehicle bears upon the surface of the roadway.Ģ7452. (c) If the width of the tire is more than nine inches, 11/2 inches thick.Ģ7451. (b) If the width of the tire is six inches but not more than nine inches, 11/4 inches thick. When any vehicle is equipped with any solid tire, the solid tire shall have a minimum thickness of resilient rubber as follows: (a) If the width of the tire is three inches but less than six inches, one inch thick. There is no requirement for trucks to carry chains during any specified time period.Ģ7450. (NOTE: Four wheel/all wheel drive vehicles must carry traction devices in chain control areas.) Requirement Three (R3): Chains or traction devices are required on all vehicles, no exceptions. ![]() Requirement Two (R2): Chains or traction devices are required on all vehicles except four wheel/ all wheel drive vehicles with snow-tread tires on all four wheels. Requirement One (R1): Chains, traction devices or snow tires are required on the drive axle of all vehicles except four wheel/ all wheel drive vehicles. ![]() There are three requirements in California. Required to be equipped with tire traction devices when entering a signed restricted area. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |